Hybrid Laser Welding Controller

MLE-300A Deeper penetration even into copper and gold!

Hybrid laser which is mixture of SHG green laser and fundamental laser enables welding of even thick copper plates. This is most suited for welding of bus bars.

MLE-300A hybrid laser welding controller is a controller to trigger START signal of both YAG SHG green laser welder (ML-8150A) and YAG fundamental laser welder (ML-2000 series).

Hybrid laser welding uses 5W YAG SHG green laser (ML-8150A) and 50 to 600W YAG fundamental laser (ML-2000 series) which are combined in a output unit and achieves deeper penetration into the materials with high laser reflectance such as copper and gold.

Its weld capability is much better than using only YAG SHG green laser. Further, this method can be replaced with resistance welding;

it improves productivity and enables welding at minute area where electrodes cannot contact.

Features

* Welding that is successfully combined outstanding features of two different lasers:

High absorptance of SHG green laser and high power of YAG fundamental laser.

* Thirty two kinds of weld schedules including waveform controls to set up.

* High repetition rate shortens takt time.

* The timing to output laser beams from two laser welders can be controlled.

* Precision welding with minute spots (0.3mm) is possible due to employment of a thin optical fiber.

* Both laser welders can be used also individually.

Expand the Environmentally-friendly Method of Welding

* Size and weight of parts can be minimized as solder is reduced.

Applications

* Heat-affected area can be reduced so that parts with weak heat resistance can be welded.

* No flux is necessary.

* No solder creeping.

* Size and weight of parts can be minimized as solder is reduced.

Applications

Welding of electronic devices, electric devices, copper and gold materials, and precision spot welding and more.