AC timer

CT-110D CY-210D Various set-ups by simple operations.

Features

* Welding mode for high-tensile steel plate.

* Clear display with LED.

* Fifteen weld schedules and nine current steps.

* Three-step welding system with up-slope and down-slope features.

* Primary and secondary constant current and power supply voltage compensated control can be selected.

* Build-in current monitor and conduction angle monitor.

* Panel cover for protection from oil mist.

* Three counters.

* Condition No. Displays the number to be registered with a certain weld schedule, and the number assigned for a registered weld-schedule for operation.

* Three-stage weld type Even steel plates, which are relatively difficult to weld, can be handled by combining the three-stage welding.

* Welding current Displays the welding current settings and measured currents at "W1: Weld I" to "Weld III".

* Current monitor/power angle monitor The current monitor allows you to set the upper and lower limits within -+1 to 49% in reference to the set current and it monitors the current fluctuation. The conduction angle monitor allows you to set its monitoring range between 1 to 180 and it monitors the maximum conduction angle.

* Step-up/counters/turns ratio of a transformer Various settings can be made by selecting a mode from 0 to 5.

*Welding On/Off If it is switched off while tip dressing or test operation, only the sequence will be ran.

* Reset Pressing this key while malfunction occurred will deactivate malfunction status.